(3) Fit the cylindrical spacer blocks to the supports of xTool D1. If one cylindrical spacer block is not high enough to engrave an object, you can add a second one, and so on.Ģ. Set the position of the adjustable roller on the rotary attachment and connect it to xTool D1. Use the engraving of a stainless-steel cup as an example.įor details about how to set the position of the adjustable roller, see "Setting the position of the adjustable roller."Ĭonnect the rotary attachment to xTool D1, as shown in the following figures.ģ. Place the rotary attachment in the middle of the working area of xTool D1.Įnsure that you have placed the rotary attachment parallel to the working area of xTool D1. Otherwise, the pattern to be engraved on the object may be deformed. (1) Set the laser head to the proper height by using the focal length setting bar, and then move the laser head over the object to be engraved. (2) Move the laser head again to position the center of the cross-shaped light beams at the start point to be engraved.Ģ. Enable Show rotary enable on main window in the Settings window that appears, and click OK.Ĥ. Set the parameters for the rotary attachment as follows and click OK.ĥ. Import the pattern you want to engrave, set the size of the pattern, and set the engraving power and speed. You can click Frame to preview the position where the pattern is to be engraved and then set the laser head to the expected position.Īfter completing the settings, click Start.Ĭurrently, the firmware supports only some functions of the rotary attachment. Start From can be set only to Current Position. For example, you can change the position of the adjustable roller from 2 to 1 as follows: Setting the position of the adjustable roller Settings on the Move tab are not available. (1) Remove the screw from the adjustable roller. (2) Pull up the support of the adjustable roller. Rotate the adjustable roller to the target position. (3) Put the support of the adjustable roller into the corresponding slot and press it into place. The side with a concave part faces away from the adjustable roller. (4) Tighten the removed screw to fix the support of the adjustable roller in the target position. Recommended settings for material parametersġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |